Analog Line Balancing

Analog Line Balancing

This must be done to each line individually, for analog lines, with the lines connected.

1. Expand ‘Line’ menu
2. For each line, do the following
   1. Click on the first line (for example, depending on card placement, ‘1’)
   2. Click the ‘Analogue Options’ tab
   3. In the section entitled ‘Impedance Match’ click the Start button. This will take a while
   4. When it pops up asking if you want to use the suggested impedance click Yes
   5. Next it asks if you want to use that impedance for all lines on the card. Click No
3. Repeat for each line
4. Don’t forget that any lines not in use need to be set to ‘out of service’ (in line settings tab)